Effect of an Al-doped ZnO electron transport layer on the efficiency of inverted bulk heterojunction solar cells

Doping is a widely-implemented strategy for enhancing the inherent electrical properties of metal oxide charge transport layers in photovoltaic devices because higher conductivity of electron transport layer (ETL) can increment the photocurrent by reducing the series resistance. To improve the conductivity of ETL, in this study we doped the ZnO layer with aluminum (Al), then investigated the influence of AZO on the performance of inverted bulk heterojunction (BHJ) polymer solar cells based on poly [[4,8-bis [(2-ethylhexyl)oxy]benzo [1,2-b:4,5-b’]dithiophene-2,6-diyl]-[3-fluoro-2[(2-ethylhexyl)-carbonyl]-thieno-[3,4-b]thiophenediyl ]] (PTB7):[6,6]-phenyl C71 butyric acid methyl ester (PC₇₁BM). The measured conductivity of AZO was ~10⁻³ S/cm, which was two orders of magnitude higher than that of intrinsic ZnO (~10⁻⁵ S/cm). By decreasing the series resistance (R_s) in a device with an AZO layer, the short circuit current (J_sc) increased significantly from 15.663 mA/cm² to 17.040 mA/cm². As a result, the device with AZO exhibited an enhanced power conversion efficiency (PCE) of 8.984%.     

Fluorescent macrocyclic chemosensor for Zn(II) detection at alkaline pH values

ABSTRACT

The new macrocyclic ligand L (28,29-dimethoxy-27-oxa-8,11,14,17,25,26-hexaazatetracyclo[22.2.1.1(2,6).1(19,23)]nonacosa-2,4,6(28),19,21,23(29),24,26(1)-octaene) has been synthesised. It contains a tetramine chain and the 2,5-bis(2-methoxy-3-metyl-phenyl)-1,3,4-oxadiazole (PPD-OMe) chromophore, acting as coordinating and sensing units, respectively.

The fluorescent emission of L depends on the pH being highly fluorescent at pH = 2 and not emitting from pH >10. The studies highlighted that L is a PET mediated emitting chemosensor, being the PET effect regulated by the degree of the tetraamine protonation.

L coordinates metal ions (Cu(II), Zn(II) and Cd(II)) in water giving rise to an OFF-ON fluorescent response for the presence of Zn(II) ion thus signalling its presence in the medium. This response is particularly notable at pH = 9 allowing to extend the Zn(II) sensing also in the alkaline pH field.     

小直径棒材超声横波检测仿真分析

采用超声水浸聚焦斜入射方式进行小棒材表面、近表缺陷检测时,声波在水/棒和棒/缺陷界面会发生反射、折射、散射、衍射及波形转换等一系列物理变换。此时缺陷可检性对声波入射条件十分敏感,常出现由于检测条件设置不当而导致缺陷漏检、误检的情况。为解决这一问题,本文针对小棒材超声斜入射检测中的主要参数——入射角和水距,开展声场及缺陷声响应仿真,研究检测参数对不同部位缺陷检测能力的影响,并对仿真结果进行试验验证。通过研究得到了检测水距、入射角度对缺陷检测能力的影响,并得到最优检测条件。试验验证结果表明研究制定的检测方案可有效检测出表面、近表面裂纹缺陷。     

Lanthanum trilactate: Vibrational spectroscopic study − infrared/Raman spectroscopy

In this study lanthanum trilactate was prepared by neutralization reaction of lactic acid and lanthanum oxide, purified and identified by X-ray powder diffraction. Infrared spectra (Mid-IR region 4000–650 cm⁻¹) and Raman spectra (Stokes region 4000–100 cm⁻¹) of the high quality crystalline samples have been recorded and presented for the first time. For comparison DFT calculations were performed using Gaussian 09 D.01 and agreement between predicted and measured spectral data has been achieved. Acquired information can be utilized for substance identification for example in various industrial applications or in biological systems.     

Study of electron-vibrational interaction and concentration quenching effect of Cu+ ions in lithium based sulphate phosphors

The objective of this work is to study electron-vibrational interaction (EVI) and concentration quenching and their manifestation in experimental photoluminescence spectra of Cu⁺ ion in various lithium based phosphors namely, Li₂SO₄, LiNaSO₄ and LiKSO₄. The main parameters of EVI, such as the Stokes shift, Huang-Rhys factor and zero-phonon line positions, were estimated. The studied systems shows strong electron lattice coupling. The validity of results was established by modeling the shape of the emission spectra, which was found to be in good agreement with experimental photoluminescence spectra. The concentration quenching study is also carried out for these compounds. The studied systems correspond to the nearest neighbor energy transfer mechanism.     

(3S,4S)-4-氨基-3-羟基-6-甲基庚酸的合成

价廉易得的L-亮氨酸先以苄基同时保护氨基及羧基得(S)-2-(二苄胺基)-4-甲基戊酸苄酯,进而在碱性条件下与乙腈发生亲核取代反应得(S)-4-(二苄胺基)-6-甲基-3-氧代庚腈,再经硼氢化钠选择性还原羰基得(3S,4S)-4-(二苄胺基)-3-羟基-6-甲基庚腈,用双氧水氧化得(3S,4S)-4-(二苄胺基)-3-羟基-6-甲基庚酸,最后在Pd(OH)2/C-H2作用下脱掉苄基得到(3S,4S)-4-氨基-3-羟基-6-甲基庚酸,即(3S,4S)-statine。整个合成路线总产率为33.6%。     

Crosslinked poly(ethylene oxide) containing siloxanes fabricated through thiol‐ene photochemistry

Homogenous amphiphilic crosslinked polymer films comprising of poly(ethylene oxide) and polysiloxane were synthesized utilizing thiol‐ene “ click ” photochemistry. A systematic variation in polymer composition was Carried out to obtain high quality films with varied amount of siloxane and poly(ethylene oxide). These films showed improved gas separation performance with high gas permeabilities with good CO₂/N₂ selectivity. Furthermore, the resulting films were also tested for its biocompatibility, as a carrier media which allow human adult mesenchymal stem cells to retain their capacity for osteoblastic differentiation after transplantation. The obtained crosslinked films were characterized using differential scanning calorimetry, dynamic mechanical analysis, thermogravimetric analysis, FTIR, Raman‐IR , and small angle X‐ray scattering. The synthesis ease and commercial availability of the starting materials suggests that these new crosslinked polymer networks could find applications in wide range of applications. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 1548–1557     

TiO2 photocatalysis for the degradation of pollutants in gas phase: From morphological design to plasmonic enhancement

TiO₂-based photocatalysis has become a viable technology in various application fields such as (waste)water purification, photovoltaics/artificial photosynthesis, environmentally friendly organic synthesis and remediation of air pollution. Because of the increasing impact of bad air quality worldwide, this review focuses on the use and optimization of TiO₂-based photocatalysts for gas phase applications. Over the past years various specific aspects of TiO₂ photocatalysis have been reviewed individually. The intent of this review is to offer a broad tutorial on (recent) trends in TiO₂ photocatalyst modification for the intensification of photocatalytic air treatment. After briefly introducing the fundamentals of photocatalysis, TiO₂ photocatalyst modification is discussed both on a morphological and an electronic level from the perspective of gas phase applications. The main focus is laid on recent developments, but also possible opportunities to the field. This review is intended as a solid introduction for researchers new to the field, as well as a summarizing update for established investigators.     

Preparation of magnetic Fe3O4/TiO2/Ag composite microspheres with enhanced photocatalytic activity

The novel three-component Fe₃O₄/TiO₂/Ag composite mircospheres were prepared via a facile chemical deposition route. The Fe₃O₄/TiO₂ mircospheres were first prepared by the solvothermal method, and then Ag nanoparticles were anchored onto the out-layer of TiO₂ by the tyrosine-reduced method. The as-prepared magnetic Fe₃O₄/TiO₂/Ag composite mircospheres were applied as photocatalysis for the photocatalytic degradation of methylene blue. The results indicate that the photocatalytic activity of Fe₃O₄/TiO₂/Ag composite microspheres is superior to that of Fe₃O₄/TiO₂ due to the dual effects of the enhanced light absorption and reduction of photoelectron–hole pair recombination in TiO₂ with the introduction of Ag NPs. Moreover, these magnetic Fe₃O₄/TiO₂/Ag composite microspheres can be completely removed from the dispersion with the help of magnetic separation and reused with little or no loss of catalytic activity.